Speakman SEF-2001-8 Installation Guide download pdf (Page 2)

With Spout fully removed, verify diameter of hole in counter top is a

minimum of 1-1/4”. Install mounting studs into base of Spout.

From beneath countertop, install Rubber Mounting Washer (1), Brass

Mounting Washer (2) and Brass Mounting Nuts (3). Align Spout square

to sink and tighten Mounting Nuts (3).

Retrieve the 6” long hose with a BLUE stripe from the box and connect

one end to the COLD supply valve. Wrench tighten.

Install Bottom Washer over hoses and slide up to meet the base of

the Spout. Place hoses through hole in countertop/sink one at a time.

Lower Spout Assembly through hole.

COLD

1 2 3 4 5 6

No comments

Speakman SEF-2001-8 Installation Guide Page 2